![]() To install, tighten to 8 Nm (71 lb-in).ĩ. Remove the 2 front bumper cover upper bolts. If equipped, disconnect the auto-park long range sensor electrical connector.Ĩ. If equipped, disconnect the fog lamp electrical connectors.ħ. Remove the 2 front bumper cover center pushpins from the front bumper cover.Ħ. To install, tighten to 5 Nm (44 lb-in).ĥ. Remove the 4 fender splash shield-to-air deflector bolts (2 each side). ![]() Remove the 6 pushpins from inside the front splash shield (3 each side).ģ. For additional information, refer to Section 100-02.Ģ. With the vehicle in NEUTRAL, position it on a hoist. NOTICE: Prior to removal of the front bumper cover, place tape at the corners of the bumper cover and below the headlamps to prevent damage to the paint.ġ. ![]() 2008 Escape/Mariner/Escape Hybrid/Mariner Hybrid Workshop Manual ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |